in , , ,

Simple Steps In Cleaning An Armstrong Air Conditioner

Simple Steps In Cleaning An Armstrong Air Conditioner

Your home’s transformation into a tranquil retreat is largely due to your Armstrong air conditioner. Regular cleaning keeps your Armstrong AC system operating at peak performance.

You’re now trying to figure out how to clean my Armstrong AC unit. No more enigmas! Here are the results of our extensive research.

Cleaning the interior and outside Armstrong air conditioning components can guarantee that your air conditioner runs effectively.

How To Clean The Indoor Unit:

Simple Steps In Cleaning An Armstrong Air Conditioner
  1. Turn off the electricity to the AC unit.
  2. Open the access panel on the AC unit.
  3. A/C evaporator coils should be cleaned.
  4. Sanitize the drain pan.
  5. After finishing, shut the access panel.

How To Clean The Outdoor Unit:

Simple Steps In Cleaning An Armstrong Air Conditioner
  1. Cut off the electricity to the outdoor unit.
  2. Get rid of the AC grille.
  3. Coil and fin cleaning
  4. Remove any clutter that may be around your outdoor unit.

That seems simple enough! Continue reading to learn more about cleaning the various components of your Armstrong AC. We’ll also go through how to diagnose and fix problems with the AC system. After that, let’s talk about it below.

How To Clean An Armstrong Air Conditioner

Cleaning your air conditioner when necessary is one of the things you can do to increase its lifespan. As a homeowner, you can accomplish a number of straightforward tasks without using a lot of time or effort.

The Evaporator Coils Must Be Cleaned

Armstrong offers two different coil cleaning techniques. If you have a type 1 coil, you can clean it out of dust with a soft brush. The form of all particles in your home is this dust.

For greater dust removal if you used a HEPA filter, you might require a vacuum. Additionally, you can quickly and effectively clean the unit’s drain pan with an accelerator gun.

In contrast, a type 2 coil cleaning method is used when the type 1 approach cannot be used to clean the coils. The best cleaning alternative is a chemical coil cleaner, which you can get at the local hardware shop.

The best way to clean and wash this chemical cleaner is using a steam cleaner. Additionally, maintaining your HVAC system’s evaporator coils helps increase airflow and power efficiency by about 30%.

The Outdoor Unit Must Be Cleaned

Check the area 2 to 3 feet around your unit to make sure there are no obstacles, such as leaves or plant growth.

Trim back overgrown vegetation and remove anything from surrounding or atop your air conditioner to ensure clear airflow.

How Is The Armstrong AC Filter Cleaned?

Although the process for cleaning filters varies based on the device, they are normally done in the same way.

  1. Disconnect the AC unit.
  2. Remove any observable leftover dirt from your AC filter by vacuuming it.
  3. The filter should be soaked in a tub or bucket filled with gentle detergent for about five minutes.
  4. Spray and rinse the filter’s two sides with caution.
  5. Before placing your air filter back into its panel, make sure it is dry.
  6. Turn the power on again.

Armstrong AC Filter: How Do I Replace It?

It’s wise to change your filter because it’s a quick and easy task that could have a significant impact on how well your air conditioner runs down the road.

You may quickly and easily replace your AC filter by following the instructions listed below:

  1. Turn off the electricity to the AC unit.
  2. Find the air filter for the AC unit.
  3. Remove the filter.
  4. Replace the replacement air filter where indicated by the arrow.
  5. Return the power to ON.

A clogged air filter can cause a 5%–15% rise in energy use. Additionally, during peak season, change or clean your AC filter every 30 or 60 days.

Your home will operate at its most energy-efficient level if you do this.

Checklist For Armstrong Troubleshooting

Simple Steps In Cleaning An Armstrong Air Conditioner

With regular repair and maintenance from your certified air conditioner technician, your system can run at its full efficiency.

However, before you speak with your HVAC dealer, problems can arise with any piece of equipment. Before hiring an HVAC professional, do this troubleshooting checklist to see if you can resolve the issue.

Your Residence Is Not Cooling

You may experience inadequate cooling or no cooling at all in your house for one of the following reasons:

Trip Breaker

Locate where your breaker panel is located. It typically appears on adjoining interior walls. To confirm that the circuits are ON, check the circuit breaker panel.

Additionally, make that the disconnect switch—which is practically next to the heat pump or air conditioner—is in the ON position. You’ll need to reset the breaker in this situation.

Thermostat Is Set To “OFF”

Check to see if your thermostat is turned on and is adjusted properly. Your home’s total level of cooling comfort will be determined by setting the thermostat to the proper setting.

The AC unit Does Not Turn Off

This is a result of an incorrect thermostat setup. Depending on the weather, set your thermostat to spend less energy when heating and cooling your home.

Additionally, your AC unit won’t be overworked as a result of this.

Blocked Air Filter

If the filter on your furnace or air handler is clogged with dust and debris, check it. If so, replace the filter on your AC unit frequently to prevent clogging and maintain smooth operation.

Coils Have Become Frozen

To check for water damage, often you can examine under your indoor unit. Additionally, look inside your indoor coil case for an icy surface.

To check if it will thaw, turn off your thermostat for one to three hours.

Clogged Ductwork

Whether the blower isn’t running, check your inside unit to see or hear if it is. Check the airflow at each vent in your home after that.

Also, ensuring clean ducting enhances the quality of the air you breathe. Armstrong asserts that it can reduce power costs by about 30%, particularly in commercial ducting systems.

It can also lengthen the HVAC system’s lifespan.

Fin Realignment

Spray the fins from the inside out with your garden hose set to a low spray setting to remove any dust or dirt that has accumulated. Keep your pressure light; too much pressure could damage the sensitive fins.

To realign the fins, you can get a fin comb from your neighborhood hardware store and utilize it. But a butter knife can also be used to delicately realign the fins.

Additionally, if any of these problems persist after you’ve troubleshooted your HVAC system, please get in touch with your HVAC dealer as soon as you can.

When Should An Air Conditioner Have Preventive Maintenance Performed?

If you registered your AC system for an extended warranty or purchased an additional service contract from your AC dealer.

  1. In the spring and fall, think about scheduling routine maintenance for your home’s heating and cooling system.
  2. Every year, just before summer, your AC unit must undergo routine maintenance.
  3. You’ll require a once-per-year schedule servicing before the winter season.

To Sum Up

Cleaning your Armstrong air conditioner keeps it in top condition and ensures that it runs as efficiently as possible. We’ve spoken about how to clean your Armstrong AC outdoor unit throughout this article.

You also know how to clean the coils and fins on your air conditioner. We also go through how to change and clean your Armstrong filters.

We are happy to impart all of this important information to you. We hope that this will assist you in maintaining and caring for your AC unit throughout its useful life.

Simple Steps In Cleaning An Armstrong Air Conditioner

What do you think?

Written by HVAC Contributor

Leave a Reply

Your email address will not be published. Required fields are marked *

GIPHY App Key not set. Please check settings

American Standard AC Not Turning On: Why And How To Fix It?

American Standard AC Not Turning On: Why And How To Fix It?

Air Filter Keeps Bending, Why And How To Fix It?

Air Filter Keeps Bending, Why And How To Fix It?